SCREEN PRINTING NANO SILVER PASTE FOR TP
Nano Silver Paste Factory
UIV Chem offers Screen Printing Nano Silver Paste for your production needs. Find product specific information including CAS, MSDS, COA and protocols.
Screen Printing Nano Silver Paste for TP
Introduction
YR-ST070-type conductive paste is designed for low-temperature curing type paste capacitive touch screen screen printing process design, and ITO, PET film and glass have good adhesion, acts as an electrode conduction current signal.
feature of product
1. Based on micro-nano technology is made, than the commercial micron conductive paste lift more than 35%;
2. optimum printing properties can reach 60 / 60μm (L / S);
3. To provide professional custom development and on-site technical support.
Project
Test Methods
Performance
Exterior
Visual
Silver paste
Viscosity
Rotational viscometer 160rpm，25℃
11,500±1,500 cP
Degree of fineness
Fineness gauge
≤ 15μm
Solid content
Burning Loss Method
60±5 wt.%
Density
Mass / volume
2.05±0.05g/mL
Square resistance
Four-probe tester
≤0.012Ω/□/mil
Adhesion force
Hundred grid test
2 and above
Adhesion
3M600# adhesive tape
No shedding
Coating hardness
Pencil Hardness Tester
≥2H
Instruction manual of Electrically Conductive Silver Paste
Substrate: ITO, PET film, glass;
Mixing: Stir well before use to restore liquidity, the proposed length of 5 to 20 minutes while stirring.
Dilution: Stir the product can be used, we recommend without diluent. For dilution, stirring again need to use special thinner ZK70 diluted, we recommend that the weight ratio of less than 1% of silver was diluted diluted evenly.
Recommended Process
Laboratory measurements show that different customers with different curing equipment and technology, curing conditions do adjusted accordingly to achieve the best cure. The cured film thickness and final resistance is affecte
d by many factors, such as screen mesh, tension, scraping gum hardness, angle, speed, sensitive adhesive thickness.
Thickness: 7 ~ 15μm
Mesh: 300-450 mesh polyester mesh or stainless steel mesh
Cure: 30min @ 135 ℃
Storage and use of Conductive Silver Paste For Rfid
1. Storage temperature: 5 ~ 25 ℃, sealed and stored in a dry, cool, dark place; use immediately after opening, the remaining product to be sealed;
2. Vacuum packaging shelf life of six months.
3. This product contains organic solvent, should be used to maintain good ventilation; should be used to avoid contact with skin, if they come into contact with skin or eyes, promptly wash with water and soap.
More information please click here.
